RV Solar System Sizing and Setup: Batteries, Panels, Controllers and Wiring
An RV solar system is sized from your daily watt-hours. Follow the battery, panel and controller math, see why 24 V helps bigger rigs, and avoid common wiring mistakes.
An RV solar system combines roof or portable panels, a charge controller, a house battery bank and usually an inverter, and you size it from the watt-hours you use each day. A typical approach is to add up daily use, size the battery to cover two or three days, then install enough panel wattage to refill that battery in about four to five hours of strong sun. A rig that uses 1,200 watt-hours a day, for example, works out to roughly 300 amp-hours of 12-volt lithium and about 700 watts of panels.
Key takeaways
- Do an energy audit first: watts times hours for every device, plus 10 to 15 percent for inverter losses on AC loads.
- Lithium batteries give you about 90 percent of their rated capacity; lead-acid about 50 percent.
- The charge controller must handle both the array's voltage and its power at your battery voltage.
- Higher system voltage (24 V or 48 V) cuts current, which means thinner cables and less heat.
- Roof air conditioning is the load that breaks most RV solar budgets.
What goes into an RV solar system
Every RV solar system has the same building blocks, though they come in many sizes:
- Solar panels: rigid panels bolted to the roof, flexible panels glued on, or portable panels you set out at camp.
- Charge controller: regulates panel power into the battery. DOE describes the controller's job as keeping the battery fully charged without over-charging it. Victron recommends MPPT controllers over PWM types, which it calls not very efficient.
- House battery bank: stores energy for evenings and cloudy days. It is separate from the engine's starting battery.
- Inverter: turns 12 V or 24 V DC into 120 V AC for household-style outlets. DOE notes that a steady voltage and smooth sine wave matter more for sensitive electronics such as computers.
- Protection: fuses, breakers, a battery disconnect and a DC-rated switch to isolate the panels.
Step-by-step RV solar sizing math
This worked example uses round numbers for a couple who boondock with a fridge, lights, water pump, fans, laptops and a TV. Swap in your own figures from device labels; DOE's formula is watts times hours of daily use, and if only amps are listed, amps times volts gives watts.
1. Total your daily watt-hours
Suppose your audit adds up to 1,200 Wh per day, including an allowance for inverter losses on AC devices. Victron's guide suggests adding about 10 to 15 percent to AC loads for those losses. Our kWh calculator helps with each device.
2. Convert to amp-hours
Divide watt-hours by system voltage. At 12 V, 1,200 / 12 = 100 Ah per day. At 24 V, it is 50 Ah per day.
3. Size the battery bank
For two days without sun at 12 V, you need 200 Ah of usable energy. Victron says lithium can typically be discharged to about 90 percent and lead-acid to about 50 percent, so:
- Lithium: 200 / 0.9 = about 222 Ah, so three 100 Ah batteries (300 Ah) give comfortable margin.
- Lead-acid: 200 / 0.5 = 400 Ah, with far more weight.
For more on bank sizing, see how many batteries an off-grid system needs.
4. Size the panels
Divide daily use by peak sun hours. At 5 sun hours, 1,200 / 5 = 240 W just keeps pace. Victron's guide recommends enough panels to fully recharge the batteries in 4 to 5 peak sun hours; in its 720 Wh example that meant about 450 to 500 W, roughly triple the break-even array. Doing the same here points to about 700 W, if your roof has room. Sun hours vary a lot by place and season; the PVWatts tool from the National Laboratory of the Rockies (pvwatts.nlr.gov) gives location-specific numbers.
5. Pick the charge controller
Controllers are rated by maximum panel voltage and output current. Victron's SmartSolar MPPT 100/30 accepts up to 100 V open-circuit from the array and delivers up to 30 A, which Victron rates as 440 W of panels at 12 V or 880 W at 24 V. So a 700 W array would overload a single 100/30 on a 12 V bank (it would limit input power) but fit within its rating on 24 V.
For voltage, add panel Voc values for panels in series. With a panel rated 21.5 V Voc, such as EcoFlow's 220 W portable model, four in series reach 86 V at standard test conditions, under the 100 V limit. Panel voltage climbs in cold weather, so that leaves only modest headroom: check the panel maker's temperature data, or use three in series (64.5 V) if you camp in the cold.
12 V vs 24 V vs 48 V for an RV solar system
Most RVs come wired for 12 V, but bigger systems often move the battery bank and inverter to 24 V or 48 V. The reason is current. Amps equal watts divided by volts, before inverter losses:
| Inverter load | Current at 12 V | Current at 24 V | Current at 48 V |
|---|---|---|---|
| 600 W | 50 A | 25 A | 12.5 A |
| 1,200 W | 100 A | 50 A | 25 A |
| 2,000 W | about 167 A | about 83 A | about 42 A |
At 12 V, a 2,000 W inverter pulls well over 150 amps from the battery, which requires very heavy cable and large fuses. Use our watts to amps calculator to check your own loads. If your RV's lights, pump and fans run on 12 V, a 24 V or 48 V bank needs a DC-DC converter to feed them.
What an RV solar system can and cannot run
- Comfortable: LED lights, water pump, vent fans, furnace blower, phones, laptops, TV, a 12 V compressor fridge. Victron's example 12 V 70-liter fridge uses about 500 Wh a day.
- With a bigger inverter and bank: microwave, coffee maker, induction cooktop and hair dryer in short bursts.
- Hard: roof air conditioners for long periods, electric water heating and electric space heating. These loads need a very large battery and array, or shore power or a generator.
Our cost to run pages list typical wattage for many appliances, which helps you decide what belongs on solar and what should wait for a campground hookup.
Choosing RV batteries: lithium vs lead-acid
Lithium iron phosphate (LiFePO4) batteries cost more up front but are lighter and last longer. Battle Born, for example, lists its 100 Ah 12 V LiFePO4 battery at $799 on sale (regular $949) in November 2026, with a 3,000 to 5,000 cycle lifespan and a 10-year warranty. DOE says deep-cycle lead-acid batteries generally last 5 to 10 years.
Two practical notes:
- Cold weather: Battle Born says LiFePO4 batteries should not be charged below about 25°F unless they have internal heating, can typically discharge down to about -4°F, and are rated to operate up to around 135°F. Its battery management system blocks charging outside safe limits. Winter campers should consider heated batteries or install the bank inside the heated living space.
- Venting: DOE notes lead-acid batteries release hydrogen and oxygen while charging and should be in a well-ventilated space away from living areas. That usually means a vented outside compartment in an RV.
RV solar setup and safety checklist
- Plan the roof layout around vents, air conditioners and antennas to avoid shading.
- Seal every roof penetration with a sealant compatible with your roof material.
- Install a DC-rated PV isolator switch between panels and controller, as Victron recommends, so you can disconnect the array for maintenance.
- Fuse every positive cable close to the battery, and size cable for the current, not just the length.
- Set the controller and inverter-charger to the correct battery chemistry profile.
- Avoid mixing old and new or mismatched batteries; Victron warns against piecing a system together from unmatched secondhand parts.
- If you also carry a fuel generator, the CPSC says to run it outdoors only, at least 20 feet from buildings, and never in an enclosed area.
High-current DC wiring and any connection to the RV's 120 V system can cause fires or shocks if done wrong. Have a qualified RV technician or licensed electrician do or inspect the battery, inverter and AC wiring, and follow the manufacturers' installation manuals.
Next steps
Start your audit with the kWh calculator, then work through the battery, panel and controller steps above. If you mostly camp for short trips and do not want to modify the roof, compare a fixed system with a power station and portable solar panels.
Frequently asked questions
How much solar do I need for my RV?
Divide your daily watt-hours by your peak sun hours to find the break-even wattage, then add extra so you can refill the battery after cloudy days. A rig using 1,200 Wh a day at 5 sun hours needs 240 W to keep pace and about 700 W to recharge quickly.
How many batteries do I need for RV solar?
Multiply daily amp-hours by the days of backup you want, then divide by usable capacity, about 90 percent for lithium and 50 percent for lead-acid. Two days at 100 Ah a day calls for about 222 Ah of 12 V lithium.
What size charge controller do I need for RV solar?
Match both the voltage and the power. Victron's MPPT 100/30, for example, accepts up to 100 V from the panels and is rated for 440 W of panels at 12 V or 880 W at 24 V.
Can RV solar run the air conditioner?
Only with a very large battery bank, inverter and array, and usually not for long periods. Most RV owners run air conditioning on shore power or a generator.
Can I charge lithium RV batteries in freezing weather?
Not safely without heat. Battle Born says LiFePO4 batteries should not be charged below about 25°F unless they have internal heating.
Should my RV solar system be 12 V or 24 V?
Small systems work fine at 12 V. Larger systems with big inverters often move to 24 V or 48 V because the same power at higher voltage means less current and thinner cables.
Sources
- Victron Energy - How to Size a Solar System for Your RV
- Victron Energy - SmartSolar MPPT 100/30 and 100/50 technical specifications
- Battle Born Batteries - 100Ah 12V LiFePO4 Deep Cycle Battery
- Battle Born Batteries - Understanding Temperature Limits of LiFePO4 Batteries
- EcoFlow - NextGen 220W Bifacial Portable Solar Panel
- U.S. DOE Energy Saver - Balance-of-System Equipment Required for Renewable Energy Systems
- U.S. DOE Energy Saver - Estimating Appliance and Home Electronic Energy Use
- CPSC - Warns of Generator, Carbon Monoxide and Fire Hazards Ahead of Hurricane Season (May 2026)
Questions and comments
Be the first to ask a question or share your experience.